To give you a better experience, we use our own and third party cookies,
You can read all about them in our cookie policy.
Budget sensored brushless 13.5T motor and 50amp ESC, ideal for budget drift setups.
Value and versatility sum up the Probe Plus ESC from Etronix. This compact brushed motor speed control is an ideal choice for most electric 1/10th applications and can handle up to 7.4v (if using LiPo use with a regulator). Factory fitted connectors and switch, the Probe Plus just needs to be mounted and plugged in to automatically find neutral before you are off. It really is that simple!
There's no quicker way to increase your Radio Controlled Car performance than a motor upgrade. When choosing an upgrade motor ensure that the electronic speed controller which you intend to use is capable of running the motor, most speed controllers will quote a motor limit, this is because the quicker the motor, the greater the current drain. Fitting a high performance motor without conforming to the limits of the ESC can make the speed controller run hot, sometimes causing it to overheat and possibly fail (the standard speed controller in a Tamiya kit or Ansmann car will handle a motor down to about 21 turns). It may also be worth considering efficiency of your car with a Ball Race Bearing Set and heavier duty connectors such as the deans type
It is also important to note that the quicker the motor the less runtime you will get, for example a standard 540 motor can run for about 10 minutes whereas a 21 turn motor will run for about half that time. So upgrading to a higher capacity battery will help to maintain your runtime. Brushed type motors, unlike there brushless equivilents require regular maintanece. It is important to make sure that they are clean of any debris inside the motor and to use a cotton wool bud coated with motor spray to clean the commutator of the motor of any carbon debris from the brushes and also to replace these motor brushes when they have worn down to half there original length. When choosing a speed controller it is important to ensure that the quoted motor limit is suited to the motor you intend to run, as a motor with a lower number of turns than the recommended limit will make the controller heat up very quickly and could cause a failure. If you intend to run a motor below 21turns you will want to improve the efficiency of your car with a Ball Race Bearings Setand heavier duty connectors such as the deans type. Most Tamiya and Ansmann cars are supplied with a speed controller suited to 21 turn motors, fitting a faster motor will require an upgrade speed controller.