Hornby OO Goods Wagons

An iron ore tippler wagon was an all-steel mineral wagon that did not have doors. Each wagon featured heavier axleboxes for carrying iron ore. The wagons could be turned over for unloading at its destination, the steelworks.
After these small capacity wagons were replaced with more modern rolling stock many of these vacuum brake fitted iron ore tippler wagons were taken over by the BR engineering departments for use as spoil carrier. TOPS coded ZKV these wagons were given the codeword Zander in the 'fishkind' series used for engineering wagons. This model comes in a bauxite livery with black patches applied to take the new lettering.

Coal haulage in South Wales was streamlined and made more efficient when GWR introduced the 21-ton mineral wagon in the 1920s. A few decades later, the 21-ton mineral wagon served an essential purpose in the early stages of British Railways control over the new national railway network.
This wagon is liveried in a Stephenson & Clarke eye-catching pale green. The hook couplings enable easier coupling of other rolling stock and locomotives on your layout. It features die-cast spoked wheels.

The breakdown crane is as much a part of railway infrastructure as much as it is a wagon. Such cranes began to appear in 1875, growing in size and complexity. 

Over 176 cranes have appeared around the UK since their introduction, with the most modern cranes able to lift entire locomotives off the ground. Being the national operator from 1948 BR inherited a patchwork of rolling stock from its constituent companies, as they had done twenty five years earlier, including all breakdown cranes in service.

BR employed some of the largest rail cranes, with the heaviest of the lot designed for the heaviest of tasks, such as the re-railing of locomotives, or tasks that may see a locomotive needing to be removed from the track all together

The SAA Steel Carrier is a type of two axle flat wagon with a very specific use which would result in their life as the SAA designation being relatively short lived. Introduced in 1966, the first withdrawals took place in 1971 following an accident at the foot of Beattock summit in Scotland. 

By 1976 over half of the wagons found themselves rebuilt and redesignated as the FPA container flat wagons, in the ten years preceding this the SAAs were under used, warranting the rebuilds. No SAA container wagons remain in service in 2023, with only a handful of the rebuilt variants still in storage.

The OAA wagon could be seen as a logical progression of the open wagons of yore, they had no explicit purpose in mind upon introduction but to haul a large amount of cargo wherever was required. Introduced in 1971 with a carrying capacity of 31 tonnes the OAA wagons had drop side doors on each side for the easy loading and unloading of cargo. 

The OAA wagons saw conversions and rebuilds within a few years of introduction as the railways undertook a move towards specific rolling stock for specific uses, and the need for general wagons became reduced. Many wagons would go on to enter departmental service. A small handful of the wagons are still in service, although these tend to be used as barrier vehicles in the modern era.

The ZBA 'Rudd' is a type of low sided open wagon rebuilt from an older HTV type of coal hopper. This rebuild was done on behalf of the BR Civil Engineering department, the department responsible for maintaining the trackwork of the UK.

The ZBA was the most extreme of these rebuilt wagons with an entirely new body fitted as opposed to having the original one cut down. The first of these rebuilds began appearing in 1984, with the wagons becoming the longest lasting type. ZBA wagons saw their withdrawal come thick and fast around 2008, with their use diminished by advancements in wagon design in the 30 years they were in service.

The ZBA 'Rudd' is a type of low sided open wagon rebuilt from an older HTV type of coal hopper. This rebuild was done on behalf of the BR Civil Engineering department, the department responsible for maintaining the trackwork of the UK.

The ZBA was the most extreme of these rebuilt wagons with an entirely new body fitted as opposed to having the original one cut down. The first of these rebuilds began appearing in 1984, with the wagons becoming the longest lasting type. ZBA wagons saw their withdrawal come thick and fast around 2008, with their use diminished by advancements in wagon design in the 30 years they were in service.

The VDA van is a type of air-braked closed van built by BR between 1969 and 1977. The vans, reminiscent of a classic vent van albeit extended served a very similar purpose to their stout predecessors. The VDA was a general use van designed to haul anything and everything. 

The VDA vans were used on 'Speedlink' services designed to quickly haul general freight around the country. The wagons were rapidly withdrawn after the 'Speedlink' service was discontinued, many of them being adopted by the engineering departments as materials carriers.
This van carries the red and yellow paint scheme applied by the Signal & Telegraph department with their SATLINK lettering and allocation to the Western region engineers.

The OAA wagon could be seen as a logical progression of the open wagons of yore, they had no explicit purpose in mind upon introduction but to haul a large amount of cargo wherever was required. Introduced in 1971 with a carrying capacity of 31 tonnes the OAA wagons had drop side doors on each side for the easy loading and unloading of cargo. 

The OAA wagons saw conversions and rebuilds within a few years of introduction as the railways undertook a move towards specific rolling stock for specific uses, and the need for general wagons became reduced. Many wagons would go on to enter departmental service. A small handful of the wagons are still in service, although these tend to be used as barrier vehicles in the modern era.

A tippler wagon is a unique type of wagon on British Railways. While many different variations on the concept exists the core functionality is the same. Loading and unloading wagons is often the most time consuming part of rail freight and to get around this the tippler wagon was designed to be unloaded via the inverting of the entire wagon on an enormous unloading jig.

The bogie tippler wagon has been employed by a number of companies including BR and Cappagh civil engineering. The first batch was built by BREL with further examples being build by Redpath Dorman Long between 1972 and 1977. Initially designed for hauling iron ore, in the modern era they can also be seen hauling quarry products and steel.

The residue of coke from heating coal was necessary to produce steel as a carbon component. A demand for coke for industrial use required frequent transport and the development or conversion of specialist coke wagons. As the density of coke is less than coal, ordinary coal wagons could not be used.

This Coke Hopper triple wagon pack contains three BR liveried wagons. The hook couplings enable easier coupling of other rolling stock and locomotives on your layout.

The TTA tanker is one of the most numerous types of tanker wagon ever seen on British railways. While far from the first or last such wagon to be used the standardised nature and relative simplicity of the mechanisms in the tank and chassis led to thousands being built during the 1960s and 70s.

This triple TTA tank wagon pack consists of three Total-liveried tank wagons with the running numbers: PR58236, PR58237 and PR58238.

The TTA tanker is one of the most numerous types of tanker wagon ever seen on British railways. While far from the first or last such wagon to be used the standardised nature and relative simplicity of the mechanisms in the tank and chassis led to thousands being built during the 1960s and 70s.

This triple TTA tank wagon pack consists of three Shell-liveried tank wagons with the running numbers: SUKO65712, SUKO65713 and SUKO65714.

The TTA tanker is one of the most numerous types of tanker wagon ever seen on British railways. While far from the first or last such wagon to be used the standardised nature and relative simplicity of the mechanisms in the tank and chassis led to thousands being built during the 1960s and 70s.

This triple TTA tank wagon pack consists of three Shell-Mex-liveried tank wagons with the running numbers: 501, 502 and 503.