To give you a better experience, we use our own and third party cookies,
You can read all about them in our cookie policy.
General purpose surface mount point motors suitable for leading UK brands of track.Supplied complete with wiring harnesses with reversible connectors and fixing screws.
10m of Red/Green/Black tripled wire. Ideal for model railway point motor use and helpful when trying to keep wiring tidy.
Each wire includes 14 strands of 0.15mm diameter wire.
25m drum of Red/Black/Red tripled wire. Ideal for model railway point motor use and helpful when trying to keep wiring tidy.
Three position on/off/on biased (momentary action, switch returns to off when released) miniature toggle switch rated at 5amp/28volt DC. Ideal for operating solenoid point motors on model railways.
Size 9mm high x 13mm wide x 7mm deep. Requires 6.35mm (1/4in) hole for fitting.
Size 9mm high x 13mm wide x 11.5mm deep. Requires 6.35mm (1/4in) hole for fitting.
Makes wiring the PL-10 series of Motors quick and easy. Just a simple push fit onto the motor terminals; the other ends are tinned and ready for the PL-39 Terminal Block, PL-50 Switch Module Unit, or PL-31 Push on Terminal Connectors.
Pack of 2 looms.
Control switch and wiring harness for connection to Peco point motors. Switch and point motor harness are supplied complete wiith connectors for the EZE-Wire system, allowing extensions to be added between the switch and motor to reach the point motor location. Heat-shrink tubing is supplied to protect and insulate joints.EZE-Wire - Plug and Play layout wiring from Expo.The EZE-Wire system uses pre-made cabling complete with spade connectors on the ends to allow point motor cabling to be installed quickly and easily. No soldering required.
This point motor is designed to operate with the lower current available from some European transformers or with DCC systems*. Operation is from a passing contact switch or probe and stud system to give a pulse from the 16v AC outlet found on most transformers. If this isn't available an uncontrolled 12v DC supply may suffice. A constant current would burn out the motor.
* Although the initial amperage from DCC systems is very high, say 10 amps, the final amps available to accessories such as point motors is very low, once the current has passed through the booster units used in DCC systems.
5m of Red/Green/Black tripled wire. Ideal for model railway point motor use and helpful when trying to keep wiring tidy.
Pack of 5 general purpose surface mount point motors.suitable for leading UK brands of track.Supplied complete with wiring harnesses with reversible connectors and fixing screws.
The Smartswitch(TM) system can be used to operate turnouts, semaphore signals, level crossing gates and barriers and other moving features. This Control Board will facilitate the control of up to 4 Servos. Watch the videos to see the potential uses and ease of installation of this system and see our Shows You How booklet No. 24 Operating Points and Signals.